Chemical Engineering: Recent submissions

  • Fabrication and Analysis of Mixed Matrix Membrane utilizing Metal Organic Framework (MOF-74) in PDMS for CO2 Gas Separation 
    Subhan, Ali (School of Chemical and Material Engineering (SCME), NUST, 2023-03)
    The fabrication of mixed matrix membranes (MMMs), which contain metal-organic frameworks (MOFs) of Ni and Cu-MOF-74 with rubbery polydimethylsiloxane (PDMS) polymer matrix, is a response to the growing concern about ...
  • Mn Loaded ZIF-8 Derived Bifunctional Electrocatalyst for Oxygen Electrode in Metal Air Batteries 
    Javed, Najla (School of Chemical & Materials Engineering SCME ,NUST, 2023)
    The challenges of global warming and a lack of power are both being exacerbated by our increased reliance on these sources. Utilizing renewable energy sources for power generation and storage must be prioritized and ...
  • Fabrication and Analysis of BoronNitride Nanosheets based Membranes for Water Treatment 
    Ayesha, Sultan (School of Chemical and Material Engineering (SCME), NUST, 2023-07)
    The current research aimed to fabricate Cellulose acetate/polyethylene glycol (CA/PEG) based mixed matrix membranes incorporated with two-dimensional boron nitride (BN) nanosheets by non-solvent induced phase inversion ...
  • Block copolymer based nanocomposite membranes for Arsenic and Selenium removal from coal-fired powerplant wastewater 
    Ali Zaidi, Syed Qamber (National University of Sciences and Technology (NUST) School of Chemical and Materials Engineering (SCME), 2023-07)
    The severity of risks caused by arsenic and selenium ions in aqueous environments are well-known. Novel thin film block copolymer based nanocomposite membranes are synthesized for an efficient removal of these toxic ...
  • DESIGN OF PRODUCTION PROCESS OF PARAXYLENE NAPHTHA 
    Memon, Muhammad Kamil; Zahid, Danyal; Saqib, Abdul Rafae; Sibghat Ullah, Muhammad (National University of Sciences and Technology (NUST) School of Chemical & Materials Science(SCME), 2023-06)
    The utilization of naphtha obtained from plastic waste and refinery holds immense potential for closing the loop on plastics and controlling the entire value chain in Pakistan. This research aims to harness indigenous raw ...
  • DESIGN AND DEVELOPMENT OF A PROCESS FOR DESULFURIZATION OF COAL 
    Ahmad Raza, Umer Imtiaz, Muntazir Mehdi, Muhammad Saqib Farooq (School of Chemical and Material Engineering (SCME), NUST, 2023-06)
    Having so many large reserves of coal, Pakistan is facing an energy crisis because coal is not being utilized. The primary purpose is that in coal incineration in electricity plant life, high sulfur content material of ...
  • DEVELOPMENT OF A PROCESS FOR THE CONVERSIONOFARL'SWASTE STREAMS TO ENERGY 
    Ayesha Noor, Azka Javed, Zarfishan Tahir, Syed Saffi Haider Shah (School of Chemical and Material Engineering (SCME), NUST, 2023-06)
    Oil sludge is a complex mixture of water, solids, heavy hydrocarbons, polycyclic aromatic hydrocarbons, and heavy metals that remains in storage tanks and facilities. Its composition varies based on the origin of the ...
  • DYNAMIC MODE CONTROLLER DESIGN OF AMMONIA PRODUCTION UNIT 
    Muhammad Hamza Afzal, Muhammad Hamza Butt, Muhammad Nofal Javed, Hassan Conteh (SCME NUST, 2023-06)
    This thesis designs dynamic mode controllers for ammonia unit to increase production, reduce troubleshooting time and automate the plant. The study begins by reviewing literature and selecting the best approach for dynamic ...
  • DESIGN15TONS/DAY PRODUCTION FACILITYOF POLYOLS FROM WASTE PET BOTTLES 
    Mohammad Haris Ali Siddiqui, Abdul Rehman Farooqui, Usama Ahmed Khan, Muhammad Adnan Iqbal (SCME NUST, 2023-06)
    As the problem of plastic waste management increases in Pakistan, the need for better and more efficient chemical recycling methods also arises. Our team worked on the utilization of waste PET (Polyethylene Terephthalate) ...
  • GREENHOUSE GAS INVENTORY AND MITIGATION PLAN 
    Ahmed, Mairah; Baig, Neeha; Hafeez, Amna; Awan, Amman Ilyas (National University of Sciences and Technology (NUST), 2023-06)
    The overreliance on fossil energy brings serious environmental problems in addition to the scarcity of energy. At the same time, the emissions of CO2 have only been rising, as suggested by our inventory analysis of the ...
  • ZERO LIQUID DISCHARGE (ZLD) PROJECT FOR THE WASTEWATER STREAMS OF ATTOCK REFINERY LIMITED (ARL), RAWALPINDI 
    Sana Ullah, Sultan Abdullah, Muhammad Bilal Jutt, Syed Hassan Irtaza Naqvi (SCME NUST, 2023-06)
    Zero Liquid Discharge (ZLD) is an innovative approach that ensures no liquid waste is discharged from the plant. This sustainable approach reduces water consumption, conserves precious resources, and helps industries and ...
  • UPGRADED TECHNOLOGIES FOR BOILER FEED WATER 
    Maham Bashir, Muhammad Saad, Amaan Malik, Saad Ur Rehman (SCME NUST, 2023-06)
    Boiler Feed Water needs to meet specific standards according to the ASME Standards for Boiler Feed Water, to produce steam that is utilized at different locations in the Attock Oil Refinery Limited (ARL). The project aims ...
  • PROCESS DESIGN OF CTA PRODUCTION WITH RE-DESIGNING OF ROTARY STEAM TUBE DRYER 
    Aqsa Amir, Muhammad Jahanzeb, Muhammad Hasan, Mian Ahsan Bari (SCME NUST, 2023-06)
    The AMOCO process is widely used to produce Terephthalic Acid from the oxidation of paraxylene. This process produces Crude Terephthalic Acid (CTA) and further purify it to Pure Terephthalic Acid (PTA) which is the ...
  • PRODUCTION OF ETHANOL USING CELLULOSIC MATERIALS 
    Syed Muhammad Haisam, Zeeshan Saifullah, Ansa Saeed, Taimoor Khurshid (SCME NUST, 2023-06)
    Due to rising demand worldwide, it is predicted that within ten years, the amount of energy consumed will increase by almost 50%. The primary source of energy, petroleum oil, is rapidly running out both in Pakistan and ...
  • PROCESS DESIGN FOR A 120 MW (GROSS) CO-GENERATION THERMAL POWER PLANT BASED ON BAGASSE AND COAL FUEL 
    Khalid Habib, Muhammad Ali Hussnain, Muhammad Salman, Usama Waqas (SCME NUST, 2023-06)
    This project aims to design a co-generation thermal power plant with a gross capacity of 120MW, which will be fueled by a combination of bagasse and coal. Bagasse, a byproduct of sugar production, will be used as the primary ...
  • UPGRADED TECHNOLOGIES FOR BOILER FEED WATER 
    Maham Bashir, Muhammad Saad, Amaan Malik, Saad Ur Rehman (SCME NUST, 2023-06)
    Boiler Feed Water needs to meet specific standards according to the ASME Standards for Boiler Feed Water, to produce steam that is utilized at different locations in the Attock Oil Refinery Limited (ARL). The project aims ...
  • DESIGN OF STABILIZER AT DISTILLATION UNIT FOR PRODUCTION OF LPG 
    Muhammad Sameer, Muhammad Osama Shahid, Umair Majeed, Awais Riaz (SCME NUST, 2023-06)
    Modern day crude oil refining at a massive scale is the backbone of the global economy. This process provides fuel for transportation, domestic use and industrial heating uses and provides feedstock for several industries ...
  • DESIGN A TERTIARY WATER TREATMENT PLANT IN A TANNERY 
    Zoha Ahmad, Zoha Arif, Areej Mahmood, Zaineb Ijaz (SCME NUST, 2023-06)
    Advance Oxidation processes (AOPs) are advanced water treatment techniques that utilize highly reactive oxidizing agents to remove or degrade organic and inorganic pollutants in water. Electro-Fenton is one of them. These ...
  • DEVELOPMENT OF PROCESS SIMULATION MODEL OF SOUR GAS PROCESSING PLANT 
    Ahmed Asad Ullah, Muhammad Junaid, Muhammad Asad Ijazn, Chaudhary Muhammad Umer Ejaz (SCME NUST, 2023-06)
    With increasingly stringent environmental regulations, industries have to be more than ever vigilant in developing technologies for processing of raw materials. Fossil fuels processing involves several threats to the ...
  • OPTIMIZATION OF HIGH SULFUR COAL IN ROTARY KILN OF CEMENT MANUFACTURING PLANT 
    Ai Hassan, Qamar Shahid, Faris Abbas, Ayeza Masroor (SCME NUST, 2023-06)
    Coal reserves in Pakistan are distinguished by their high sulfur content ranging from 5% to 7%. The combustion of fuel containing undesired compounds presents substantial challenges to the cement manufacturing industry, ...

Search DSpace


Advanced Search

Browse

My Account